6
The intent of this section is to familiar-
ize the operator with the flow of the
program and what to expect with each
key press. Each program screen of
the servo will be displayed and also
comments to clarify possible questions.
There are four sections that will be
explained and they are as follows:
SECTION 1 —
JOB NUMBER
SECTION 2 —
MANUAL MODE
SECTION 3 —
AUTOMATIC MODE
SECTION 4 —
REVIEW JOB PARAMETERS
When the servo is first started, and
has performed its startup procedure,
the first screen displayed should look
like this:
MAIN SELECTION MENU
F1=JOB NUM F2=MANUAL
F3=AUTOMATIC (CYCLE)
F4=REVIEW PARAMETERS
*SELECT F1=JOB NUM
The first step in programming a job is
to select a two digit job number which
will be used to store the parameters
that the operator inputs or to recall
an existing job number that was
previously loaded. When the operator
presses F1 on the keypad, the screen
will change to:
JOB SELECTION MENU
ENTER JOB NUMBER=_____
PRESS F4 KEY AFTER
CORRECT # IS ENTERED
The next screen lets you program
parameters or exit with the existing
parameters.
oPerATor inPUT seCTion
Operator Input Section
INCH MODE:
F1=JOG FORWARD
F2=JOG REVERSE
F4=RETURN
When the F1 key is pressed, the feed
will advance the material at a slow
rate of speed. When the F2 key is
pressed, the feed will reverse the
material and run at a slow rate of
speed. Press F4 to return to the
main screen.
With the main menu displayed
and pressing the “F3 AUTOMATIC
(CYCLE)”, the following screen
appears:
AUTOMATIC JOB=01
FEED LENGTH= _____
PRESS SPEED= _____
F4=RETURN
In the automatic mode, the feed
length and operator entered press
speed will be displayed. Whenever
the press mounted feed switch is
activated, the servo will feed the
feed length displayed on the screen.
Because there is not an interface in
the control for the pilot release it will
be up to the customer to wire the pilot
release switch to the solenoid that
operates the raising of the rolls.
Press F4 button to return to the main
menu and deactivate the automatic
control.
Press F4 again and the final mode is
review parameters, the parameters
for the job number will then be
displayed.
JOB NUMBER= _____
F1=PROG. PARAMETERS
F4=DON’T ALTER VALUES
Pressing the “F1 PROG. PARAMETERS”
key initiates the following screen.
Key in the required parameters.
FEED LENGTH= _____
PRESS SPEED= _____
FEED ANGLE= _____
* Once the parameters have been
entered, the program will complete
the math routine which selects the
proper accel./decell. and motor speed
for the parameters listed and then the
main menu is displayed again.
* SELECT F2 MANUAL
If the operator elects to move the
material from the feed to the die
electrically, the manual mode has to
be selected. Pressing the F2 key will
bring up the manual mode screen.
MANUAL LENGTH= _____
F1=SINGLE _ FEED
F2=GO TO INCH MODE
F4=RETURN
Each time the F1 key is pressed,
the servo will move the material
the feed length entered for the job
number. The material will move at
the speed required to keep up
with the programmed press strokes
per minute.
If the operator would like the material
to move a slower rate then the inch
mode should be selected. Press F2
now to display the inch mode screen.
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels