Rapid-air SERVO FEED WITH PILOT RELEASE: KBX SERIES Manuel d'utilisateur télécharger pdf (Page 28)

TROUBLESHOOTING CHART (cont.)

PROBLEM CAUSE REMEDY

Material feeds off Edge guides not set Set edge guides

center properly

Material not centered Center material

to feed

Bad Material Try new roll of material

No automatic cycle No press signal Check limit switch

input to servo control

Controller fault Check lights on drive

Servo fault Check lights on drive

Program error Check parameters

on display

Servo squeals while Servo velocity gain Consult factory

too high

Belt too loose or tight Readjust belt tension

Fault signal on Pac-Sci Servo fault Recycle power

is displayed Material jam Check die

Power surge/failure Check/recycle power

Cannot program unit Program fault Check Pac-Sci &

from display call factory.

Data Instruments Check Data Instruments

interface jumper loose connection

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Rapid-air SERVO FEED WITH PILOT RELEASE: KBX SERIES Manuel d'utilisateur Page 28