Rapid-air SMART MINI-SERVO GAG FEED Manuel d'utilisateur

1RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.comsmart min

10ProGramminG ProCedUre (ContinUed)F1, batch/total, on the “RAMP/COUNTER” screen leads to: EXIT SET COUNTER VALUES SET RESE

110.1.2.3.4.5.6.7 (not flashing)7.89Ab.cE.F.IHh or h.IJJ. oº.P. (.flashing)P. (.steady)r•S--.=S1•troUbleshootinGDisplay DescriptionInternal communic

12There are two CAN LEDs , the left LED shows activity on the CAN1 (CANopen) bus. The right LED shows activity on the CAN2 (Baldor CAN) bus. Each LED

13led statUs symbolsSymbol DescriptionDrive / comms watchdog. Internal communications failure. Clear the error; if the problem persists then conta

14led statUs symbols (ContinUed)Symbol DescriptionPower base not ready. This error condition applies only to 3-phase models. These drives have a p

15led statUs symbols (ContinUed)Symbol DescriptionPreset trapezoidal move active (in motion).DB Overload. The regeneration resistor (Dynamic Brake

16SMS Control Panel Assembly

17SMS Wiring Schematic

18ALL SALES BY THE COMPANY ARE MADE SUBJECT TO THE FOLLOWING TERMS AND CONDITIONS. PLEASE READ.WARRANTY – The Company warrants, for a period of one

2INTRODUCTION, INSTALLATION AND SET-UP ... pg. 3ADJUSTMENT, CABLING

3The Rapid-Air Servo Feed system carries with it the quality and reliabil-ity you have grown to expect from a Rapid-Air product. The motion control s

4Every servo feed has an eccentric adjustment screw to adjust the upper roller to be in parallel to the lower roller. The maximum adjustment is .008”

5Now that your servo is in place, and the cables have been attached, you can proceed with testing the unit. The first step is to turn on the main swit

6No power indicationNo display on operators consolePower on – no motionMaterial will not enter rollsMaterial will not feedMaterial feeds shortMateria

7Problem Cause RemedytroUbleshootinG (ContinUed)Material feeds off ce

8Operator Interface Terminal ProGramminG ProCedUreThis section is to familiarize an opera-tor with the terminal screen (program) flow. Also, the secti

9ProGramminG ProCedUre (ContinUed)corresponds to Output 1 in the electri-cal wiring diagram. Entering 1 will turn an output on at the end of each fe