1RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.comair feed
10The attempt is made to start the machine by pulling the mushroom start button but no lights illuminate.The attempt is made to cycle the feed but th
11Problem Possible Causes Remedycharacteristics and possible causes of troubles with rapid-
12Problem Possible Causes Remedycharacteristics and possible causes of troubles with rapid-
13Problem Possible Causes Remedycharacteristics and possible causes of troubles with rapid-
14Programming Procedure
15Programming Procedure
16Air Feed Speed Adjustment
17Programming Procedure
18Electrical Assembly
19Operator Keypad
2INSTALLATION AND MECHANICAL SET-UP OF DIE OR PUNCH ... pg. 3AIR FEED PROGRESSION SET-UP AND MAI
20Control Panel Wiring Diagram
21Rapid Master Unit with Air Feed
22Rapid Master Mechanical Setup
23ALL SALES BY THE COMPANY ARE MADE SUBJECT TO THE FOLLOWING TERMS AND CONDITIONS. PLEASE READ.WARRANTY – The Company warrants, for a period of one
3The Rapid Master that you have just re-ceived is fully assembled and ready to be put into production. Due to shipment vibration and handling, the ma
4The feed guide rollers are adjustable by loosening the machine screws and moving the rollers to the desired posi-tion. For best result, the stock sh
5For a general guide for the Rapid Master, the lubricator oil release adjustment should be set to one drop of oil for each 50-80 strokes. (See insert
61. Master power on/off buttonLighted 2 position switch, located on the side of the console. When turned on the switch should illuminate.2. Tonnage
7A. Taut stock inputThis is a normally open contact from a switch or device that monitors the loop of material prior to the air feed. When the mater
8The intent of this section is to familiarize the operator with the program flow and what to expect with every keypress. Each screen on the display wi
9The unit is now in full automatic. Whenever an input for feed is received, the air feed will feed the cycles programmed and increment the counter by
Commentaires sur ces manuels